Boilers

XFyre (Condensing)

Buy XFrye by Raypak Fan Assisted Boilers in Michigan - Raypak-Fan-assisted1_(1)The Raypak family of XFyre Hydronic Boilers, 300A-850A, feature 94% efficiency, whisper quiet operation, and is available for natural gas or propane.

Key Features

  • Top-side water connections - allows side by side installation.
  • All models are equipped with 316L welded stainless steel heat exchanger and copper plumbing. ASME Section IV constructed and stamped. National Board Registered AB 1953 low lead compliant.
  • Multiple pump outputs - Boiler Pump, System Pump, Indirect Pump.
  • Spark ignition with remote flame sensor.
  • Electronic modulating gas valve and burner, up to 5:1 turndown.
  • Certified under SCAQMD Rule 1146.2.  Meets all Low NOx regulations.
  • Supports inlet water temperature down to 50F.
  • Whisper quiet operation.
  • On-board diagnostic center, English, no codes.
  • 0-10 VDC BMS Interface (setpoint or direct drive).
  • Built-in cascade function for up to 4 boilers.
  • VERSA IC® control package with built-in outdoor reset function.
  • Complete cabinet protects all controls and wiring.
  • Tough rust-resistant powder coat finish.
  • Easy to service - removable air filter.
  • Certified for PVC, CPVC, Polypropylene or stainless vent materials.
  • Suitable for altitudes up to 10,000 ft. (derate may apply).
  • Available for natural gas or propane.

 

Brochure, Use & Care Manual, Spec Sheet

Raytherm® Atmospheric Boilers & Water Heaters

Design simplicity, quality materials, and meticulous craftsmanship have earned Raypak a rock-solid reputation for reliability. While others busily design cost out of their products, Raypak has continued to engineer dependability in.

XTherm (Condensing)

96% Efficiency (Cat.IV) Hydronic Boiler
97% Efficiency (Cat. IV) Domestic Hot Water UP to 99% part load
3 models – 1,000,000, 1,500,000 and 2,000,000 BTUH

Time-honored technologies unite with cutting edge advancements in Raypak's XTherm modulating vertical heater.

Hi Delta

84% Standard Boilers
85% Standard Water Heaters
18 models from 120,000 to 2,340,000 BTUH
Copper fin tube style boiler for domestic hot water and Hydronic heating applications. This budget-friendly model has flexible designs with many options including dual fuel gas train (Nat. /LP), stackable, cold water start / cold water run solutions and many control configurations.

Delta Limited

84% Standard Boilers
85% Standard Water Heaters
12 models from 399,000 to 2,340,000

Copper fin tube style boiler for domestic hot water and Hydronic heating applications. This model is a cost effective solution.

MVB

Up to 85% Efficiency (Cat. I) Up to 88.4% Efficiency (Cat. IV) 12 models from 500,000 to 2,000,000 BTUH Modulating copper fin tube style boiler with the smallest installed footprint of any vertical boiler. CSA certified from 84% to 88% efficiency, highest for a non-condensing boiler.

EVO

80,000 to 8,000,000 BTU
Hamilton Engineering’s full line of condensing combustion products (EVO Boilers with Innovative Condensing Technology) are the mainstream in energy and emissions saving technology today.

Custom System Solutions

A Hamilton Engineering Custom System Solutions are built and sized to meet the space constraints and your floor plan. Factory designed, engineered, and pre-fabricated for your specific individual project. Why take days on site when this takes just minutes to set up to start making system field connections?

EVO Boilers & Water Heaters with Innovative Condensing Technology

The EVO family of products was designed from the ground up, using technology and components that have been proven in millions of products since 1992, assuring you proven, simple, efficient technology that is identical throughout our entire product line. If you can understand, set up and service our HW 79 product, you can do the same with our HW 1999. Our EVO products are virtually identical, with the exceptions of internal operating software and a few safeties, as required by code.
We have worked with Performance Engineering Group going on 20 years now. Over the years, we have installed over 200 pieces of their equipment. They have been very easy to work with and have always given us great service. Mary Marble, Marble Mechanical Service, LLC